4 .
Using the up arrow, slowly raise the print pad one press at a time . While the print
pad is being raised, slide the gap gauge back and forth under the left print jet .
Once you feel a slight resistance on the gap gauge, remove the gap gauge from
the print pad .
5 .
Press the white space to the right of CAL 2: .
NOTE: This illustration shows the target area where you need to
press .
NOTE: The printer will begin the calibration .
6 .
Record the value for CAL 1: .
NOTE: This value will need to be used again in this procedure .
NOTE: The printer will display a value for CAL 2: .
7 .
Select the checkmark to save the values .
8 .
Navigate to the Printer Calibration screen and select CALIBRATE .
9 .
Select
Auto
Gap .
3D Systems, Inc.
96