3D Systems Cube User Manual page 22

4 . Mount the cartridge on the right side of the printer and select the
continue .
NOTE: It may become necessary to slightly rotate the cartridge to
seat it properly .
NOTE: The print jet will begin to heat . Once the print jet has reached
the proper temperature, the printer will prime melted material into
the refuse bin .
5 . The right cartridge has been installed . Select the
6 . Select PRINT .
7 . It is recommended that Auto Level is performed prior to the first print. Ensure
the print pad is clean and installed properly and then select the
continue to Auto Level .
NOTE: Auto Level should be performed when the printer is
positioned away from bright lights or direct sunlight .
NOTE: When installed properly, the print pad magnetically attaches
to the adjustment knobs .
3D Systems, Inc.
checkmark
checkmark to continue .
checkmark to
18
to