Print Pad Calibration; Auto Level - 3D Systems Cube User Manual

PRINT PAD CALIBRATION

Print pad calibration is performed at the factory but should be performed routinely to ensure quality printing . The printer may
occasionally prompt you to perform the Auto Level and Auto Gap procedures . If your creations are not printing as expected, check the
level of the print pad . Once Auto Level has been performed, perform the Auto Gap procedure .
NOTE: Auto Level should always be performed before the Auto Gap procedure .
NOTE: Auto Level should be performed when the printer is positioned away from bright lights or direct sunlight .

Auto Level

Print Plate Calibration
1 . Navigate to the
2 . Clean the print pad thoroughly removing all glue and debris . Select the
checkmark to continue .
NOTE: The surface of the print pad must be completely clean .
NOTE: The Auto Level procedure will begin .
3 . Once the Auto Level procedure has completed, select the
the Z-Gap (Step 8) . If the print pad is out of range, continue with the procedure .
3D Systems, Inc.
AUTO LEVEL .
screen and select
checkmark
89
to verify