3D Systems Cube User Manual page 101

NOTE: The printer will set the Auto Gap .
4 . Compare your recorded CAL 1: value with the Auto Gap value .
NOTE: If the recorded CAL 1: value is within +/- 0 .05 of the value
displayed on the Auto Gap Successful screen, press the power
button next to the touchscreen display and do not save the value .
NOTE: If the recorded CAL 1: value is greater than +/- 0 .05 of the
value displayed, select the checkmark to save this value .
5 . Navigate to the Print Plate Calibration screen and select
6 . Clean the print pad thoroughly removing all glue and debris . Select the
checkmark
to continue .
NOTE: The surface of the print pad must be completely clean .
NOTE: The Auto Level procedure will begin .
3D Systems, Inc.
AUTO LEVEL .
97