3D Systems Cube User Manual page 110

4 . Select the print jet you would like to purge and select the
5 . Using the pliers from the tool kit, carefully pull down the material sleeve .
Caution: Do not pinch or twist the filament sleeve.
6 . Using the pliers, grasp the print material just above the sleeve and push the
material upward .
NOTE: Once the print jet begins to purge, the upward pressure will
allow the feeder to engage the print material .
Caution: Exercise caution when handling the print material to
ensure it does not break .
7 . Continue to push the print material upward until the print jet begins purging .
NOTE: Once the print jet reached the operating temperature, it will
begin to purge .
NOTE: After purging, the print jets will cool down .
3D Systems, Inc.
checkmark to continue .
106