3D Systems Cube User Manual page 25

NOTE: If Auto Gap is not successful, it is recommended that you
perform Auto Level and Auto Gap again . Select
continue .
NOTE: If Auto Gap is not successful the second time, select
MAINTENANCE . For more information, refer to the section titled
Print Pad Maintenance . Once the Plate Maintenance procedure has
been performed, perform Auto Level and Auto Gap .
NOTE: If Auto Gap is still not successful, select
ADJUSTMENT . Refer to the section titled Manual Gap Adjustment for
more information . Once the Manual Gap Adjustment procedure has
been performed, note the final reading for future reference.
4 . Select PRINT .
NOTE: The printer will continue the process of printing the welcome
message test print . Select
print this test print at any time . Navigate to the System 1 screen and
select TEST PRINT . Follow the prompts in the touchscreen display .
NOTE: If the color built into the test print does not match a color
of one of the installed print cartridges, the printer will assign an
installed cartridge color to the test print . Select the
continue .
5 . Gently squeeze the bottle and apply two thin layers of Cube Glue to the print
checkmark
pad . Select the
NOTE: For more information about applying glue to the print pad,
refer to the section titled Applying Cube Glue .
NOTE: Apply enough glue to cover a square area of 5" (15 cm) .
NOTE: For best results, allow the glue to dry prior to printing .
NOTE: The printer will begin to heat and then begin printing the
welcome message test print .
3D Systems, Inc.
SKIP to bypass this test print . You can
to continue .
AUTO LEVEL to
PLATE
MANUAL GAP
checkmark to
21