Replacing The Jet Wipers; Procedure - 3D Systems Cube User Manual

REPLACING THE JET WIPERS

After a predetermined number of print jet cycles over the jet wipers the display will prompt the user to replace the wipers before printing
another creation .
NOTE: When the left jet wiper has reached the end of its useful life,
the printer will prompt you to replace it . Select the
continue .
NOTE: When the right jet wiper has reached the end of its useful
life, the printer will prompt you to replace it . Select the
continue .
NOTE: If you have replaced the jet wiper, select the
reset the printer count . Press

Procedure

1 . Remove the purge bin assemblies from the printer .
3D Systems, Inc.
checkmark
checkmark
checkmark
SKIP to be reminded later .
87
to
to
to