3D Systems Cube User Manual page 118

4 . Carefully lift the print platform (A) and tape the spacer (B) to the printer in the
location shown .
5 . Remove the print pad from the printer .
6 . Place the lower insert on top of the print pad and fold the sides outward .
7 . Move the print jet mount to the center of the printer and place the top insert over
the mount .
NOTE: The top insert is designed to keep the sides of the lower
insert pressed outward .
8 . Place the printer in the protective bag and then place it in the lower foam support
in the box .
3D Systems, Inc. 114
A
B