3D Systems Cube User Manual page 24

NOTE: When prompted, tighten the lock screw enough to ensure
the adjustment knob does not easily turn . Select the checkmark to
perform Auto Level again .
Caution: Do not over-tighten the lock screw . This can damage the
adjustment knob and void the manufacturer's warranty.
4 . Select the checkmark
5 . Install the print pad and select the
NOTE: To install the print pad, place it on top of the adjustment
knobs . When the print pad is centered properly, magnets will secure
the print pad to the adjustment knobs .
NOTE: The printer will perform an automated gap measurement .
6 . Select the checkmark
NOTE: The value presented on the touchscreen display is the
absolute print pad position . Note and refer to this value when
performing the Manual Level procedure . Your number may differ
from the illustration .
3D Systems, Inc.
to continue .
checkmark to perform Auto Gap .
to continue .
20