Bravo-Brava
Electrical equipment
Alarm
55.
PROGRAMMING CODES WITH MANUAL ACCESS
From the moment the memory is "closed", the introduction of further remote control codes takes place
by "manually opening the memory". This opening should be carried out following the instructions given
in points 1 to 12 working in rapid succession.
Start of manual opening of the memory
(entering a known password)
- The method for entering the password is as
follows:
1. Press the button in the receiver for around
2 seconds: the LED should flash.
2. Release the button: after about 2 seconds
the LED will flash briefly indicating that it
is possible to introduce the first figure of
the password.
5 impulses
Immediately press the button for the re
ceiver as many times as indicated by the
first digit of the password (for example: 5
times);
it should be noted that for each impulse
the LED will come on briefly to give a vi
sual confirmation.
Copyright by Fiat Auto
HI-96 - Cancels and replaces
145