Bravo-Brava
Electrical equipment
Recharging
55.
Voltage
(V)
Voltage
(V)
-40
-20
0
+20
+40
+60
+10
P4A113L06
° C
Electronic regulator ambient temperature
15
14,5
14
13,5-
13-
P4A113L03
NOTE
To remove the cover (1) (positioned
on the positive battery terminal), act
gently using a screwdriver in the
position shown by the arrow, until
the fixing pins come out.
1 . Checking current intensity
- Fit the ammeter plierson the alternator ca
ble/junction unit
- start up the engine and let it run at be
tween 3000 and 4000 rpm;
- switch on all the available consumers;
- measure the maximum current intensity
supplied on the multimeter display.
If this value is more than 5A below the rec
ommended figure, overhaul the alternator.
2. Checking voltage
- Place the multimeter probes in contact
with the battery terminals;
- start up the engine and let it run at be
tween 3000 and 4000 rpm;
- gradually switch on several consumers
until the absorbtion is about half the maxi
mum load.
Under these circumstances the voltage read
ing should be between the maximum and
minimum values (see diagrams) depending
on the ambient temperature of the electronic
regulator (alternator).
-40 -20
0 +20 +40 +60 +80 + 1 0 0 ° C
P4A113L07
B
Diagram A refers to an
RT 121A electronic reg
ulator which is incorpo
rated in M. Marelli alter
nators, whilst diagram
B refers to the EL 14V
4C electronic regulator
which is incorporated in
Bosch alternators.
Copyright by Fiat Auto
113