Replacing Vehicle Roof Panel - Fiat Brava Service Manual

Bravo-Brava Bodywork
Replacing body panels
70.
REPLACING VEHICLE
ROOF PANEL (7090A 58)*
(*) This number indicates the operation
code given in the Flat rate manual.
The component for which the replace­
ment procedure is given is highlighted in
the diagram at the side.
P4A089M01
PRELIMINARY PROCEDURES
Establish the extent of the damage, check if there are distortions to the connected components by
checking the bodyshell alignment figures, using suitable methods (jigs, templates or gauges).
Carry out any straightening operations required to the bodyshell before cutting the component.
After this operation check that the components not being replaced are in tact.
PRELIMINARY DISMANTLING
Remove the moving parts of the bodywork and interior fittings, which could impede the repair opera­
tions or be damaged during them.
REMOVING
Cut the vehicle roof panel using a power saw following the dotted lines shown in the diagram below.
The most important sections of the body panel are shown in order to allow the operator to adjust the po­
sition and the depth of the cutting so as not to damage the panels underneath.
P4A089M02
When carrying out the operations described, adhere strictly to the safety procedures. Protective
shoes, ear-muffs and gloves should be worn during the cutting operations, we/ding masks and
gloves during the we/ding operations, and a protective mask and gloves during the painting
operations.
0
Copyright by Fiat Auto
89