Fiat Brava Service Manual page 518

Bodywork
Window glasses
70.
Refitting
For the preparation of the glass and the housing, refer to the instructions already described previously
(see page 50).
The rear window glass has an extruded trim (1) along the entire perimeter. The sealant (2) which sticks
the window glass to the bodyshell is applied to the trim in a continuous bead along the entire perimeter.
The measurements for the dimensions of the bead and the distance from the edge of the trim are given in
inset B.
P4A058M01
There are two housings (3) at the two front corners of the window for fitting the threaded pins (4)
which act as references for the centering. The section of the window corresponding to the threaded
pins is shown in inset C.
The threaded pins are available as spares and it is advisable to modify two of them, removing the tabs to
use them as reference pins during the operation of offering up the window when dry.
To lock the window, during the hardening of the sealant, fold back the clips (5) as shown in inset A.
Bravo-Brava
58
Print no. 506.670