Bodywork
Seat belt pre-tensioner
Bravo-Btava
70.
REMOVING BRACKET
The removal of the bracket (3 in the diagram overleaf) prevents the pyrotechnic device from ac
cidentally being activated. This operation should be carried out each time a service opera
tion which may cause the accidental activation of the device is carried out. The bracket should
ALWAYS ONL Y BE REFITTED with the pre-tensioner unit fitted on the vehicle in order to pre
vent injury to the personnel carrying out the operation
3 door version
(A) Direction of travel
Break the protective collar (5) (guarantee
seal), undo the fixing bolt (4) and remove the
bracket (3) (also see diagram at the top of
the page overleaf).
Undo the bolt (2) which fixes the pre-ten
sioner (1) to the bodyshell and extract the
pre-tensioner from inside the pillar.
5 door version
(A) Direction of travel
Break the protective collar (5) (guarantee
seal), undo the fixing bolt (4) and remove the
bracket (3) (see diagram atthe foot of the
page overleaf).
Undo the bolts (2) fixing the pre-tensioner
support to the bodyshell and remove the sup
port (6) assembly and the pre-tensioner (1)
from the pillar and separate the two compo
nents.
38
Print no. 506.670