Simplified Programming; Programming Country Code - Fiat Brava Service Manual

Electrical system
Alarm
Bravo-Brava
55.
S I M P L I F I E D PROGRAMMING
The memorization of a remote control must al­
ways take place w i t h :
- alarm off (dissuasion LED off)
- ignition key removed or at the STOP or PARK
positions
- emergency key switch (except for versions for
the British market which do not have it) at the
ON position
With this programming system, all the codes of
the remote controls, w i t h no limit as to quantity,
are "recognized", but only the last 8 remain
stored in the alarm system's memory as follows:
1. press and hold d o w n the button (5) on the re­
ceiver, built into the front central courtesy
light; the adjacent warning light (LED) (4)
should flash;
2. still holding d o w n the button (5), press the
button (3) on the remote control;
3. then release the button (3) on the remote
control when the LED (4) on the receiver
stays on permanently;
4. release the button (5) on the courtesy light to
conclude the procedure.
1. Remote control warning light (LED)
2. 4-digit access code (password)
3. Remote control button on ignition key
4. Warning light (LED) on front central cour­
tesy light
5. Programming button
If the LED (4) on the receiver stops flashing and goes out when the remote control button (3) is
pressed, this means that the receiver's memory is closed, so "PROTECTED" programming should be
To memorize the subsequent remote controls, repeat the above-mentioned operations.
Programming country code
Procedure a)
After memorizing the remote controls as described above, within 15 seconds of releasing the button (5)
of the receiver on the courtesy light, the code of the country where the alarm system has to operate must
be memorized.
The country code is programmed by pressing the button (5) of the receiver in rapid succession n times
(see table below). The LED (4) will flash at each press of the button.
If the button (5) is not pressed, the system sets itself to the country code previously memorized; if there
is none (1st programming), the system sets itself automatically to the operating mode for "ITALY".
N O T E The 15 seconds are reduced to 3 from the second memorization onwards.
COUNTRY CODE
(presses of button)
1
2
3
4
COUNTRY OF
OPERATION
ITALY
GERMANY
FRANCE
SWITZERLAND
COUNTRY CODE
(presses of button)
5
6
7
8
COUNTRY OF
OPERATION
UNITED KINGDOM
BELGIUM
HOLLAND
EEC
/ / the procedure has been carried out correctly, the warning light (LED) (5) on the receiver will
flash n times (where n is the selected country code number), confirming that the code has been
memorized by both the receiver and the control unit; if not, the LED (5) comes on and stays
on for 5 seconds; at this point it will be necessary to repeat all the programming operations
starting from point 1.
For cars intended for the British market, if the LED does not come on again, this means that the
control unit is not connected to the receiver or is not supplied.
N O T E To programme the country code, you can use the procedure with the FIAT/LANCIA Tester
and the other diagnostic systems.
4
XII-97 - Update
Publication no. 506.670/14