Bodywork
Replacing body panels
Bravo
70-
Removing off cuts and preparing edges of bodyshell
1. Remove the weld points along the entire perimeter of the edge of the bodyshell and the reinforce
ment below the light cluster housing as shown in the inset using a special cutter.
2. Remove the metal off cuts using pliers.
3. Straighten the edges with a hammer and dolly block.
4. Remove the weld residues using a disc grinder.
5. Apply the IVI Epox epoxide type primer or an electro-weldable galvanized paint or an equivalent pro
duct, to the areas previously ground.
Preparing the spare part
1. Make equidistant holes in the edges of the replacement part shown in the diagram.
2. Remove the anti-corrosion treatment from the entire perimeter of the inside and the outside of the re
placement part using a disc grinder.
3. Use electro-galvanizing paint on the edges previously treated.
V
^ v O
-
94
Print no, 506.670/01