Window Glasses; Wire; Instructions For Using Wire Contained In Kit - Fiat Brava Service Manual

Hide thumbs Also See for Brava:

Table of Contents

Window glasses

i r _ - = i - '

The tool illustrated in the diagram

must be used to cut the bead of

sealant with the wire.

1. Traction handle

2. Retaining tool

Instructions for using wire contained in Kit

Cut a segment of wire about 50 cm long and

introduce one end of the wire (part 1 detail

A) through the bead of sealant (heat the wire

and use pliers to facilitate this operation).

Fix the end of the wire to the retaining tool

inside the vehicle and the other end to the

traction handle outside the vehicle. The op

erator inside the vehicle should introduce the

retaining tool into the bead of sealant (FIG.

B) about 30 cm from the point where the

wire passes (detail A).

The other operator outside the vehicle should

pull the handle following the line of the

windscreen surround and cut the bead of

Repeat the operation at 30 cm sections, suit

ably reducing the length at the corners of the

window, until the sealant bead is completely

Print no. 506.670

Show Quick Links

Table of Contents