Replacing Rear W I N G (3D); Replacing Rear W I N G (5D) - Fiat Brava Service Manual

Brava
Bodywork
Replacing body panels
70.
REPLACING REAR
WING (7090A 54)*
(*) This number indicates the operation
code given in the Flat rate manual.
The component for which the replace­
ment procedure is given is highlighted in
the diagram at the side.
PRELIMINARY PROCEDURES
P4A081M01
Establish the extent of the damage, check if there are distortions to the connected components by chec­
king the bodyshell alignment figures, using suitable methods (jigs, templates or gauges).
Carry out any straightening operations required to the bodyshell before cutting the component.
After this operation check that the components not being replaced are in tact.
PRELIMINARY DISMANTLING
Remove the moving parts of the bodywork and interior fittings, which could impede the repair opera­
tions or be damaged during them.
REMOVING
Cut the rear wing of the vehicle using a power saw following the dotted lines shown in the diagram be­
low and remove the spot welds along the section of the door striker housing.
The most important sections of the body panel are shown in order to allow the operator to adjust the po­
sition and the depth of the cutting so as not to damage the panels underneath.
P4A081M02
When carrying out the operations described, adhere strictly to the safety procedures. Protective
shoes, ear-muffs and gloves should be worn during the cutting operations, we/ding masks and
gloves during the we/ding operations, and a protective mask and gloves during the painting
operations.
Copyright by Fiat Auto
81