Bravo
Bodywork
Replacing body panels
70.
Where it is not possible to use a spot weld remover, use a special cutter and an ordinary drill (it is also
possible to use a normal drill modified as shown in the diagram underneath.
mm0,4~
^ S 3
I
% %
Z
I
Remove the rear wing taking care not to distort the inner frames.
// there are difficulties when removing the wing, it is advisable to heat the section of sealant in
the area of the wheel arch and the foam in the upper part of the rear pillar using a hot air bio wer.
Copyright by Fiat Auto
71