Electrical system
Various devices
Bravo-Brava
55.
STOP LIGHTS SWITCH
To replace the stop lights switch, closely fol
low the procedure below:
Dismantling
- Disconnect the electrical connections
block;
- withraw the switch, turning it anti-clock
wise by about 60°;
This operation is facilitated if a wrench is
used on the hexagonal section (1) in the
central figure.
Refitting
- Fit the new switch complete with bush (2)
and spacer (3) in its seating (4) as follows:
- hold the brake pedal depressed, then fit the i
new switch in the engagement position on
the bracket (4);
- turn the switch by about 60° clockwise to
the limit of its travel. The retaining lug (5)
should be heard engaging in its seating
(6).
Regulation
- Release the brake pedal to the rest position;
the switch will be positioned automatically
in relation to the bush (2);
- press the pedal so that the working spacer
(3) used as protection during adjustment
can be removed and scrapped.
NOTE
The working spacer (3) releases an
inner stop lug which prevents any
further
movement
between
the
switch and bush (2).
REVERSING LIGHTS SWITCH
3. Disconnect the connector indicated and
undo the gearbox switch, taking care to
avoid leakage of oil.
44
Publication no. 506.670/01