Fiat Brava Service Manual page 567

Hide thumbs Also See for Brava:

Table of Contents

Replacing structural body panels

REPLACING FRONT CROSS MEMBER

LINING (7090G 07)*

(*) This number indicates the operation

code given in the Flat rate manual.

The component for which the replace

ment procedure is given is highlighted in

the diagram at the side.

PRELIMINARY PROCEDURES

Establish the extent of the damage, check if there are distortions to the connected components by

checking the bodyshell alignment figures, using suitable methods (jigs, templates or gauges).

Carry out any straightening operations required to the bodyshell before cutting the component.

After this operation check that the components not being replaced are intact.

PRELIMINARY DISMANTLING

Remove the moving parts of the bodywork and interior fittings, which could impede the repair opera

tions or be damaged during them.

Cut the vehicle front cross member cover using a power saw following the dotted lines shown in the di

agram below.

The most important sections of the body panel are shown in order to allow the operator to adjust the po

sition and the depth of the cutting so as not to damage the panels underneath.

When carrying out the operations described, adhere strictly to the safety procedures. Protective

shoes, ear-muffs and gloves should be worn during the cutting operations, we/ding masks and

gloves during the we/ding operations, and a protective mask and gloves during the painting

Show Quick Links

Table of Contents