Brava
Electrical equipment
Lighting
55.
Replacing tail light cluster
1. Remove the tail light cluster as described
on page 26.
2. Before fitting the tail light cluster, ensure
that the frame fastening the light cluster to
the body is positioned half way along the
length of the gasket preload adjustment
screws. Otherwise adjust the screws as
shown in the figure.
3. Correctly position the tail light cluster on
the body and tighten the retaining screws
shown in the figure.
4. Gradually tighten the screws in the order
shown, then continue to tighten to break
point.
The above operation allows the gas
ket between the tail light cluster and
body to be adjusted to the correct
pressure.
NOTE
Finish refitting the parts by reversing
the instructions for tail light removal.
Copyright Fiat Auto
26/1