Table of Contents
Advertisement
WARNING!
• If you are required to drive with the liftgate
open, make sure that all windows are closed,
and the climate control blower switch is set at
high speed. Do not use the recirculation mode.
Gas props support the liftgate in the open
position. However, because the gas pressure
drops with temperature, it may be necessary to
assist the props when opening the liftgate in cold
weather.
Liftgate Emergency Release
As a security measure, a liftgate emergency
release is built into the liftgate latching mecha-
nism. To access the liftgate emergency release,
proceed as follows:
1. Remove the rear headrests and fold down the
seats completely.
2. Take the screwdriver from the tool box
supplied.
3. With the screwdriver, remove the yellow tab.
4. Press the screwdriver into the seat in order to
trigger the release trunk tab (follow the
direction arrow to open).
32
UNIVERSAL GARAGE DOOR
OPENER (HOMELINK) — IF
EQUIPPED
HomeLink Buttons
• HomeLink replaces up to three hand-held
transmitters that operate devices such as garage
door openers, motorized gates, lighting or home
security systems.The HomeLink unit is powered
by your vehicles 12 Volt battery.
• The HomeLink buttons that are located in the
overhead console or sunvisor designate the
three different HomeLink channels.
• To operate HomeLink, push and release any of
the programmed HomeLink buttons. These
buttons will activate the devices they are pro-
grammed to with each press of the correspond-
ing HomeLink button.
• The HomeLink indicator light is located above
the center button.
Before You Begin Programming HomeLink
For efficient programming and accurate transmis-
sion of the radio-frequency signal, it is recom-
mended that a new battery be placed in the
hand-held transmitter of the device that is being
programmed to the HomeLink system. Make sure
your hand-held transmitter is programmed to
activate the device you are trying to program
your HomeLink button to.
Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the channels
of your HomeLink before you use it for the first
time.
If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or, on the
Internet at HomeLink.com for information or
assistance.
Advertisement
Table of Contents
