Maintenance Procedure (Periodical Check Parts); Cleaning Of The Electrostatic Charger Wire; Cleaning Of The Timing Roller - Konica Minolta bizhub C203 Service Manual

3. Periodical check
3.5

Maintenance procedure (periodical check parts)

NOTE
• The alcohol described in the cleaning procedure of maintenance represents the
isopropyl alcohol.
3.5.1

Cleaning of the electrostatic charger wire

A. Periodically cleaning parts/cycle
• Electrostatic charger wire: when toner cartridge K is replaced
B. Procedure
1. Open the front door.
[1]
3.5.2

Cleaning of the timing roller

A. Periodically cleaning parts/cycle
• Timing roller: Every 60,000 prints (upon each call)
B. Procedure
1. Open the right door.
[1]
22
2. Slowly pull out the charger-cleaning
NOTE
• Move the charger-cleaning tool
slowly all the way to the end of
either way.
A02EF2C501DA
2. Using a cleaning pad with alcohol,
A02EF2C001DA
Field Service Ver. 1.0 Jul. 2007
tool [1] as far as possible.
Next, slowly push in the charger
cleaning tool as far as possible.
Repeat the above operations three
times.
wipe the timing roller [1] clean of dirt.