Konica Minolta bizhub C203 Service Manual page 386

Field Service Ver. 1.0 Jul. 2007
C. Leading Edge Adj. (Duplex Side 2)
Functions • For individual types of paper, this function allows the adjustment of the image write
start position in the sub scan direction on the 2nd side of duplex printing.
Use • This adjustment is made when the image on the 2nd side of paper deviates from the
original position in the sub scan direction.
• This adjustment can be made independently for each of plain paper, thick paper 1/
1+, thick paper 2, and thick paper 3.
Adjustment
Specification
Width A
Adjustment If width A is longer than the specifications, make the setting value smaller than the cur-
Instructions rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
Setting/ 1. Place A3 paper on the manual bypass tray.
Procedure 2. Call the Service Mode to the screen.
3. Touch [Machine] → [Printer Area] → [Leading Edge Adj. (Duplex Side 2)].
4. Select the [Plain Paper].
5. Press the Start key to let the machine produce a test pattern.
6. Check the dimension of width A on the test pattern.
7. If width A falls outside the specified range, change the setting using the [+] / [-] key.
8. Press the Start key to let the machine produce a test pattern.
9. Check the dimension of width A on the test pattern.
10.If width A is outside the specified range, change the setting again and make a check
again.
11.If width A falls within the specified range, touch [END].
12.Following the same procedure, adjust for Thick paper.
Width A on the test pattern produced should
fall within the following range.
Specifications: 4.2 ± 0.5 mm
Backside
Setting range: -3.0 mm to +3.0 mm
A00JF3C504DA
10. Service Mode
(in 0.2 mm increments)
341