Konica Minolta bizhub C203 Service Manual page 435

10. Service Mode
10.9.9 Line Mag Setting
Functions • To set whether to use the offset value which has been set prior to the shipping.
Use • To be used after replacing the CCD unit.
After replacing the CCD unit, the default value needs to be set since the magnifica-
tion offset value between the lines set for each unit changes to control the differences
in reading performance on each scanner (CCD).
• The original offset value can be disabled to address image failure and other problems
caused by individual CCD performance difference.
Setting/ • The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes valid by turning the sub
power switch OFF and ON again.
390
"ON"
Field Service Ver. 1.0 Jul. 2007
OFF