Konica Minolta bizhub C203 Service Manual page 387

10. Service Mode
D. Centering (Duplex 2nd Side)
Functions • To vary the print start position in the main scan direction for each paper source in the
2-Sided mode.
Use • The image on the backside of the 2-sided copy deviates in the main scan direction.
Adjustment
Width A
Specification
Adjustment • If width A is longer than the specifications, make the setting value smaller than the
Instructions current one.
• If width A is shorter than the specifications, make the setting value greater than the
current one.
Setting/ 1. Call the Service Mode to the screen.
2. Touch [Machine] → [Printer Area] → [Centering (Duplex 2nd Side)].
Procedure
3. Select the paper source to be adjusted.
4. Press the Start key to let the machine produce a test pattern.
5. Check the dimension of width A on the test pattern.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
7. Press the Start key to let the machine produce a test pattern.
8. Check the dimension of width A on the test pattern on the backside of the copy.
9. If width A is outside the specified range, change the setting again and make a check
again.
10.If width A falls within the specified range, touch [END].
11.Following the same procedure, adjust for all other paper sources.
(Use A4 or 8
342
•Width A on the test pattern produced should
•For measurement, use the image produced
Backside
Specifications: 3.0 ± 0.5 mm
Setting range: -3.0 mm to +3.0 mm
A00JF3C505DA
1 / × 11 plain paper for the manual bypass tray.)
2
Field Service Ver. 1.0 Jul. 2007
fall within the following range.
on the backside of the test pattern.
(in 0.2 mm increments)