Field Service Ver. 1.0 Jul. 2007
6.4
Punch loop length adjustment (PK-515)
NOTE
This adjustment must be made in any of the following cases:
• When a slant occurs in the punch hole position.
• When misfeed frequently occurs in punch hole mode.
1. Call the Service Mode to the screen.
See P.330 of the main body service manual.
2. Touch [Finisher].
3. Touch [CB-FN adjustment].
4. Touch [Punch Regist Loop Size].
6. Touch two times [END].
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
9. Make a copy again and check the deviance of punch hole position.
5. Set the correction value using the [-]/
• Adjustment range: +4 max. and -4
min. (1 increment: 1 mm)
• To make loop length larger, enter a
positive value.
• To make loop length smaller, enter a
positive value.
A01GF3E508DA
6. Finisher operations
[+] keys.
65