Konica Minolta bizhub C203 Service Manual page 350

Field Service Ver. 1.0 Jul. 2007
<Relay Printing>
• It will be displayed when the following setting is set to "ON."
[Service Mode] → [FAX] → [System] → [Display Setting] → [Relay]
Functions • To set whether to use the relay print function.
Use • To print out the document that the machine relayed during relay TX.
• The relay print will be output in the following case.
1. When the relay delivery completes appropriately.
2. When the delivery job is cancelled halfway by turning OFF sub power switch.
3. When the delivery job is cancelled due to redial over.
4. When main power switch is turned OFF/ON during relay print error.
5. When delivery job is deleted in user operation during redialing.
6. When delivery job is deleted in user operation during relay delivery.
Setting/ • The default setting is OFF.
Procedure
<Destination Check Display Function>
Functions • To set whether or not to display the list of specified addresses when sending the fax.
Use • To use when displaying and checking the list of specified addresses when sending
the fax.
Setting/ • The default setting is OFF.
Procedure
(2) Memory RX Setting
• It will be displayed only when the following setting is set to "ON."
[Service Mode] → [FAX] → [System] → [Display Setting] → [Compulsory Memory RX]
• It will not be displayed when [PC-FAX RX Setting], [Forward TX Setting] or [TSI User Box
Setting] is set to "ON."
• It will not be displayed when the following setting shows that vendor is mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
Functions • To set whether to use the forced memory RX function.
Use • To store the received text in the hard disk without printing, and print it out when
ordered.
Setting/ • The default setting is NO.
Procedure
• Enter the password (up to 8 digits) for printing when set to [ON].
(3) Closed Network RX
• It will be displayed when the following setting is set to "ON."
[Service Mode] → [FAX] → [System] → [Display Setting] → [Closed area RX]
Functions • To set whether to use the closed network function.
Use • To receive data only from the device which password matches.
Setting/ • The default setting is OFF.
Procedure
• When set to [ON], enter the password (up to 4 digits) to be used.
ON
ON
8. Utility Mode
"OFF"
"OFF"
305