Lan Mode; User Alias - Sony IPELA PCS-XG100 Operating Instructions Manual

Primary DNS
Enter a primary DNS address.
Secondary DNS
Enter a secondary DNS address.

LAN Mode

Allows you to select the interface type and
the communication mode of the LAN
connection.
Auto: The interface type and the
communication mode are detected
automatically.
1000Mbps: Connects via 1000BASE-T.
100Mbps Full Duplex: Connects via
100BASE-TX in full duplex mode.
100Mbps Half Duplex: Connects via
100BASE-TX in half duplex mode.
10Mbps Full Duplex: Connects via
10BASE-T in full duplex mode.
10Mbps Half Duplex: Connects via
10BASE-T in half duplex mode.
LAN
Basic Setup:
LAN1: IPv6
Notes
• When "Internet Protocol" is set to "IPv4/
IPv6" in the Administrator setup menu, the
setup screen for IPv6 appears. In such cases,
configure the LAN mode in the IPv6 setup
screen.
• "IPv4/IPv6" for "Internet Protocol" will be
supported in version 2.0.
DHCP Mode
Allows you to select whether the Dynamic
Host Configuration Protocol (DHCP) server
is enabled.
Auto: The IP address, network mask,
gateway address and DNS address are
automatically assigned.
Off: Disables the DHCP server. In this case,
enter an IP address, network mask,
gateway address and DNS address.
Prefix Length
Configure the prefix length of the IPv6
address within the range of 0 to 128.
IP Address
Enter the IP address.
Gateway Address
Enter the default gateway address.
Primary DNS
Enter a primary DNS address.
Secondary DNS
Enter a secondary DNS address.
LAN Mode
Allows you to select the interface type and
the communication mode of the LAN
connection.
Auto: The interface type and the
communication mode are detected
automatically.
1000Mbps: Connects via 1000BASE-T.
100Mbps Full Duplex: Connects via
100BASE-TX in full duplex mode.
100Mbps Half Duplex: Connects via
100BASE-TX in half duplex mode.
10Mbps Full Duplex: Connects via
10BASE-T in full duplex mode.
10Mbps Half Duplex: Connects via
10BASE-T in half duplex mode.
LAN
PPPoE
PPPoE
Allows you to select whether to use PPPoE
for LAN connection.
Off: Does not use PPPoE.
LAN1: Uses PPPoE for LAN connection
using the 1 (LAN1) connector (
(LAN) connector on the PCS-XG77/
XG77S).
LAN2: Uses PPPoE for LAN connection
using the 2 (LAN2) connector.
Notes
• The "LAN1" setting is called the "On"
setting on the PCS-XG77/XG77S.
• The "LAN2" setting is not available on the
PCS-XG77/XG77S.
• The PPPoE registration status appears at the
bottom of the screen for each page.

User Alias

Enter a user name when you use PPPoE for
LAN connection.
Registering Local Information
79