Sony IPELA PCS-XG100 Operating Instructions Manual page 237

d STANDBY lamp
The orange lamp lights when the system
is set to standby mode using the remote
commander.
Rear
5 6 7 8 9 0 qa qs
e SYSTEM SELECT switch
Note
The factory default position is "6". Do not
change this position, as the other positions
are used only for servicing.
f HDMI video connector
Supplies the images as a HDMI video
signal or DVI video signal.
g IR SELECT switch
This switch is used only for servicing.
h VISCA IN connector
To communicate via RS-232, use this
connector. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
i VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
j LAN connector (RJ-45 8-pin)
Used only for servicing.
k DC 12V connector
Connect the supplied camera cable.
l Reset switch
This switch is used only for servicing.
Bottom
qd qf qg
qg qh
m BOTTOM switches
This switch is used only for servicing.
Note
Do not change the factory default position
displayed at the bottom of the unit.
n Tripod screw hole (1/4-20UNC)
When you use a tripod screw, use this
screw hole to fix it.
o Mounting screw hole (M3)
Use this hole to secure a bracket, etc.
p Hook-and-loop pad attachment
points
When using the supplied hook-and-loop
pads, attach them near the specified
points.
Important
The nameplate is located on the bottom.
HD Camera Unit Parts Identification
qh
qh qg
237