Using A Second Camera - Sony IPELA PCS-XG100 Operating Instructions Manual

Using a Second Camera

You can connect the second camera through the camera unit.
Connection example for a second camera
First camera
to DVI-I 1
IN
Connect the video output connector of the second camera to the HDMI IN,
DVI-I 1 IN, or DVI-I 2 (PC) IN connector at the rear of the Communication
System.
Note
The HDMI IN connector is not available on the PCS-XG77/XG77S.
Select "DVI-I 1", "DVI-I 2" or "HDMI" in "Second Camera Input" of the
Camera setup menu depending on the connector to which the camera is
connected.
Note
The "HDMI" setting is not available on the PCS-XG77/XG77S.
To switch the picture shot by two cameras
When you open the Camera menu, the instruction "F2: Switches to the first
camera." or "F2: Switches to the second camera." is displayed at the bottom of
the monitor screen. Each press of the F2 button on the Remote Commander
changes the picture shot by each camera.
For the procedure how to open the Camera menu, see "Adjusting the Camera"
on page 144.
VISCA cable
(not supplied)
to VISCA OUT
DVI cable (not supplied)
Second camera
to VISCA IN
to Video
output (DVI)
Using a Second Camera
175