Troubleshooting - Sony IPELA PCS-XG100 Operating Instructions Manual

Troubleshooting

If the Communication System does not function correctly, check the following.
Symptom Cause
The power of the The power switch is not set to on.
system is not turned
on.
The batteries in the Remote
Commander are low or dead.
The power of the The DC 12V connector of the
SRG-120DH HD supplied camera cable is not fully
Camera Unit is not connected.
turned on.
The Remote Pairing with the Remote
Commander does Commander fails.
not operate.
No sound or the The volume of the system is too
volume is very low. low.
The volume of the TV monitor is
too low.
The microphone on the remote
party is turned off.
Audio input is not selected
properly.
The microphone or external
equipment is not connected
correctly.
Picture is blurred. Manual focus is selected but picture
remains blurred.
When auto focus is selected, the
background is too bright, contrast is
too high, or the background or the
participants' clothes contain fine
line patterns.
Solution
Press the power switch to turn on the
power of the system (page 42).
Replace the batteries with new ones
(page 39).
Make sure it is connected fully and
securely.
Perform pairing of the Remote
Commander with the System (page
40).
Adjust the sound volume by pressing
the VOLUME +/– buttons on the
Remote Commander (page 44).
Adjust the volume of the TV monitor.
Ask the remote party to turn on the
microphone.
• Set up "Input Select (MIC)" on the
Basic Setup1 page of the Audio
setup menu properly (page 72).
• Set up "Audio Input" properly on
the Basic Setup1 page of the Audio
setup menu (page 72).
Check the connection (pages 173 and
177).
Adjust the focus (page 150).
Select manual focus and adjust
manually (page 150).
Troubleshooting
257