System Connections; When Used In Lan (100Base-Tx/10Base-T); (With One Camera And One Monitor) - Sony PCS-G70 Integration Manual

1-3. System Connections

This section describes the typical system connections.
m
. Be sure to turn off all the equipment before making any connections.
. Do not connect/disconnect the camera cable with the power on. Doing so may damage the camera unit
or communication terminal.
. For safety, do not connect the 100BASE-TX/10BASE-T connector to a network that applies an excess
voltage via the 100BASE-TX/10BASE-T connector.

1-3-1. When Used in LAN (100BASE-TX/10BASE-T)

(with one Camera and one Monitor)

PCS-PG70/PG70P
Communication terminal
MCU VIDEO OUT
1 2
DC 19.5V IR OUT
1 2
AUDIO
OUT
to DC19.5V
Audio cable
*
supplied
**
not supplied
m
. If the system uses only one camera, be sure to connect it to the MAIN CAMERA connector.
. The AUDIO OUT (MIXED) jack is used to make an audio recording of a conference. This is not used
during regular conferences.
PCS-G70/G70P
PCSA-CG70/CG70P
Camera unit
TERMINAL VISCA OUT
to TERMINAL
Camera cable
to MAIN CAMERA
AUDIO OUT AUDIO IN MAIN SUB
(MIXED) AUX LINE CAMERA AUX IN CAMERA AUX IN
MIC
(PLUG IN POWER)
1 2
3 4 5
WHITE 100BASE-TX/
1 2
EC-MIC RGB OUT BOARD 10BASE-T DSB
AUX CONTROL
CTRL-S 1 2 ISDN UNIT
AUX MONITOR
VIDEO OUT
to
to
to 100BASE-TX/
VIDEO OUT
10BASE-T
MONITOR 1
*
S-video cable
UTP cable (category 5, straight)
*
to
S-video
input
to audio input
*
PCS-AC19V6
AC adaptor
Power cord
to a wall outlet
**
to LAN
**
TV monitor
to a wall outlet
*
1-5