To configure the presentation mode, set "H.239" to "On" on the IP: Mode page
(page 69) or on the ISDN: Mode page (page 70) of the Communication setup
menu.
To start a presentation
1
Press the TOOLS button on the Remote Commander to open the Tools
menu.
2
Press the b button on the Remote Commander and press the V, v, B or b
button to select "Execute" for "Presentation".
The RGB picture from the computer is transmitted to the remote party.
While presentation is being executed, the message "Executing" appears on
the screen.
Tools
Home
Machine Status
Setup
Note
You can also transmit the computer picture to the remote party by pressing the
PRESENTATION button on the Remote Commander instead of performing steps
1 and 2 above.
To stop the presentation
Select "Stop" for "Presentation" in the Tools menu and press the ENTER
button on the Remote Commander. Transmission of the computer picture
stops.
You can also stop the presentation by pressing the PRESENTATION button
on the Remote Commander.
Stop
Presentation
[Executing]
Streaming
[Suspended]
Execute
Recording
[Suspended]
Execute
Annotation
[Suspended]
Execute
Icon display
On
Off
Reject Answer
Screen Capture
Execute
Using the Computer Picture for Presentation
163