Sony IPELA PCS-XG100 Operating Instructions Manual page 241

m DC 12V connector
Connect the supplied camera cable.
Bottom
qf qg qh
qh
n BOTTOM switches
Used for RS-232C and RS-422
switching, 9,600 bps and 38,400 bps
baud rate selection, D70 mode switching
and IR signal output setting.
For details, refer to the Technical
Manual for the camera unit.
Note
This is not available on the PCS-XG100/
XG77/XG100S/XG77S.
o Tripod screw hole
p Ceiling bracket mounting screw
holes
Important
The nameplate is located on the bottom.
Setting of the SYSTEM SELECT
switch
This switch allows you to select the video
format of the signal to be output from the
VIDEO OUT connectors.
Notes
• Be sure to set this switch before
connecting the PCS-XG100/XG77/
XG100S/XG77S.
• Be sure to use a Phillips-head screwdriver
when changing the switch position. If you
use a tool other than the designated
screwdriver, the crossed groove may be
damaged.
• HDTV video signal outputs display
without distortion on monitors with 16:9
aspect ratios.
qh
Switch Video format
position
1080i/
0
59.94(29.97PsF)
1 1080p/29.97
720p/59.94
2
3 720p/29.97
NTSC(LB)
4
5 No output
HD Camera Unit Parts Identification
Set this arrow to
the desired video
format.
Support
–
Yes
59.94 Hz
Yes
system
Yes
No
– –
241