Starting An Encrypted Connection - Sony IPELA PCS-XG100 Operating Instructions Manual

Starting an Encrypted Connection

You can start an encrypted connection by calling a remote party in the same
manner as a daily connection.
During an encrypted connection, the encryption icon,
Note
If there is no icon displayed, transmitted and received data are not encrypted. Confirm
if an icon is displayed before starting a connection.
When the encrypted connection is disabled
If the following message appears when you call a remote party, an encrypted
connection is not available.
Error Messages
The far-end system is not
compatible with the encryption
feature.
The encryption feature on a far-
end system is disabled.
The encryption feature on a far-
end system is enabled.
The conference could not start
because the encryption feature at
the near-end side was disabled.
The conference could not start
because the encryption feature at
the far-end side was disabled.
The conference could not start
because the signal encryption
method at the near-end side
differed from that of the far-end
side.
H
Causes
The remote system is not equipped with an
encryption feature.
The encryption feature on a remote system is
turned off or the signal encryption method setting
on the remote system is different from that on the
local system.
The encryption feature on a remote system is
turned on.
"Encryption Mode" is set to "Off" on the local
system.
The encryption feature on the remote system is
disabled.
The encryption method setting on the remote
system is not the same as that on the local
system.
Starting an Encrypted Connection
, is displayed.
187