Qos Setup Menu; Packet Resend Request (Arq); Arq Buffering Time - Sony IPELA PCS-XG100 Operating Instructions Manual

Description
Enter the description of this terminal. By
default, "Videoconference Device" is
entered and can not be changed.
Location
Enter the location where this terminal is
installed (up to 30 characters).
Contact
Enter information about the terminal
administrator (up to 30 characters).

QoS Setup Menu

Specifies the functions for providing
optimum consistent communication.
Notes
• When "Lip Sync" is set to "Off" in the Audio
setup menu, you cannot change the setting
for "Adaptive Rate Control (ARC)", "Packet
Resend Request (ARQ)" or "Forward Error
Correction (FEC)".
• When "Adaptive Rate Control (ARC)",
"Packet Resend Request (ARQ)" or
"Forward Error Correction (FEC)" is set to
"On", you cannot set "Lip Sync" to "Off" in
the Audio setup menu.
• The QoS function is not available during SIP
connections.
QoS1
Basic Setup
Adaptive Rate Control (ARC)
Allows you to select whether to always
optimize the LAN bandwidth.
On: Always optimizes the LAN bandwidth.
Off: Does not optimize the LAN bandwidth.
Auto Bandwidth Detection
Allows you to select whether you use the
Auto Bandwidth Detection feature.
On: Enables the Auto Bandwidth Detection
feature.
Off: Disables the Auto Bandwidth Detection
feature.
TCP Port Number
Enter the fixed TCP port number.
82
Registering Local Information
UDP Port Number
Enter the fixed UDP port number.
For details on the port numbers used on the
system, see "List of Port Numbers Used on
the PCS-XG100/XG77/XG100S/XG77S" on
page 271.

Packet Resend Request (ARQ)

Allows you to select whether to request
packet to be resent when packet losses occur
during communication.
On: Requests packets to be resent.
Off: Does not request packets to be resent.
Note
When a multipoint connection is made among
six points or more with "Packet Resend
Request (ARQ)" set to "On", the maximum
bandwidth to be used will be restricted.

ARQ Buffering Time

Set the buffering time used for "Packet
Resend Request".
You can select from among "300ms",
"150ms", "80ms", "Auto" and "Custom".
When "Custom" is selected, you can specify
any buffering time.
ARQ Buffering Time
Enter the buffering time (50 ms to 999 ms)
when you select "Custom" in "ARQ
Buffering Time".
Forward Error Correction (FEC)
Allows you to select whether received
packets are identified with an error
correction mark.
On: Identifies with an error correction mark.
Off: Not identify with an error correction
mark.
Auto: Automatically determines whether to
identify or not identify with an error
correction mark based on the "Forward
Error Correction (FEC)" setting of the
remote party.
Note
When "Forward Error Correction (FEC)" is set
to "On", the maximum bandwidth to be used is
restricted to 8 Mbps.