Sony IPELA PCS-XG100 Operating Instructions Manual page 243

Hd visual communication system
Hide thumbs Also See for IPELA PCS-XG100:
Table of Contents

Advertisement

Rear
5 6 7 8 9
e DC IN 12V connector
Connect the supplied camera cable.
f SYSTEM SELECT switch
Used for selecting the video format of
the signal to be output from the VIDEO
OUT connectors.
For details, see "Setting of the SYSTEM
SELECT switch" (page 243).
g IR SELECT switch
Select the camera number when you
operate multiple cameras with the same
remote commander.
Note
This is not available on the PCS-XG100/
XG77/XG100S/XG77S.
h VISCA IN connector
To communicate via RS-232C, use this
connector. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
i VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
j VIDEO OUT connector
Bottom
0
k BOTTOM switches
l Tripod screw holes (1/4-20UNC)
m Fixing screw holes (M3)
Setting of the SYSTEM SELECT
switch
This switch allows you to select the video
format of the signal to be output from the
VIDEO OUT connectors.
• Be sure to set this switch before
Supplies the images as an analog
component signal. Digital signals are
also output from this connector.
qs
qd
Used for RS-232C baud rate selection,
turning the remote control signal output
on/off, and selecting whether to add
sync.
Note
This is not available on the PCS-XG100/
XG77/XG100S/XG77S.
When you install the camera to a tripod,
secure the tripod to these screw holes.
Used for fixing the camera to a fitting
using M3 screws.
Notes
connecting the PCS-XG100/XG77/
XG100S/XG77S.
HD Camera Unit Parts Identification
qa
243

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ipela pcs-xg100sIpela pcs-xg77Ipela pcs-xg77s

Table of Contents