Loading Media (Sc-F7100 Series) - Epson SC-F7100 series User Manual

SC-F7100 Series/SC-F7000 Series

Loading Media (SC-F7100 Series)

This section describes the methods to load media.
!
Caution:
❏ The after heater may be hot; observe all
necessary precautions. Failure to observe the
necessary precautions could result in burns.
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
Injury may occur if the media falls.
A
Remove the media holding plates, if installed.
B
Turn on the printer by pressing the P button.
C
Loosen the roll holder fixing screws sufficiently
and adjust the roll holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
User's Guide
Basic Operations
D
28
c
Important:
If the right holder handle shaft is not visible,
rotate the handle as shown in the illustration
below until it stops. The media cannot be
properly loaded if the handle shaft is not
visible.
Place media on the roll support oriented
according to how it is rolled (see below) and
position it as indicated by the mark on the label.
Printable Side Out
Printable Side In
If the label does not have the loading position,
mark it on the label as instructed in the Setup
Guide.
U Setup Guide