Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
I
Tighten the roll holder fixing screw until the
screw no longer turns to fix the roll holder in
place.
c
Important:
If the roll holder fixing screw is loose, the roll
holder may move during printing. This
could cause stripes and unevenness in the
print results.
J
Rotate the handle until part A in the illustration
below is fully inserted.
User's Guide
Basic Operations
K
L
M
30
c
Important:
Once part A is hidden, do not turn the
handle any further. Failure to observe this
precaution could damage the roll holder.
If part A is still visible even after the handle
has been turned fully, rewind the handle.
Loosen the roll holder fixing screw on the
right side, and then restart from Step 8.
Confirm that the right and left edges of the
attached roll are aligned.
If the right and left edges of the roll are not
aligned, realign them.
Raise the media loading lever.
Pull out the media and insert it into the printer.
Advertisement
Table of Contents
