SC-F7100 Series/SC-F7000 Series
D
Media info
❏
From left to right, this display shows the selected
media, platen gap, media width, and media
remaining.
❏
If a media setting bank number created with this
printer is selected as the print media, the number
(from 1 to 30) will be displayed. When RIP Settings is
selected, 0 will be displayed.
❏
The selected platen gap is shown as follows.
: 1.5
: 2.0
: 2.5
❏
The media remaining is not displayed if Off is selected
for Remaining Setup in the Media Remaining menu.
"The Media Setup Menu" on page 91
U
E
Chip unit status
The display changes as shown below when an error is
detected in the installed chip unit.
Normal
User's Guide
Introduction
Warning or error
19
1 Status indicators
The chip unit status is indicated as follows.
: No error. Ready to print.
: An error occurred. Check the message
on the screen, and clear the error.
: The chip unit could not be recognized
or it is not compatible with the printer.
Or, the slider is not locked.
Check the on-screen message.
: Check the ink level in the ink tank, and
then replace the chip unit and refill the
ink correctly.
As it gets closer to time to replace the
chip unit,
"Chip Unit Replacement and Ink
U
Refills" on page 81
2 Ink color codes
BK : Black
Y
: Yellow
M
: Magenta
C
: Cyan
F
Waste Ink Bottle status
Displays the approximate amount of space available
in the Waste Ink Bottle. The display changes as
shown below when the waste ink bottle is nearly full
or an error occurs.
Normal
will begin to flash.
Warning or error
1