Epson SC-F7100 series User Manual page 130

SC-F7100 Series/SC-F7000 Series
Media Feeding Unit
A
Confirm that the printer is off.
B
Open the front cover and raise the media loading
lever.
C
Use the large hexagon wrench to loosen the four
fixing screws on the rear of the printer as shown
in the illustration.
User's Guide
Appendix
D
E
130
Loosen the roll holder fixing screws and adjust
the roll holders so that the distance between the
two is wider than the roll core.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle as shown in the
illustration below until it stops.
Tighten the roll holder fixing screw to align the
left roll holder with the position of dotted line.