SC-F7100 Series/SC-F7000 Series
c
Important:
If the left roll core handle shaft is not visible,
rotate the handle as shown in the
illustration below until it stops.
C
Insert the roll core into the right roll holder. Next,
insert the left roll core holder into the roll core,
and then tighten the roll core holder locking
screw.
User's Guide
Appendix
D
E
F
125
Rotate the handle until part A in the illustration
below is fully inserted.
Bring film a to the left side of film b. Pass the lead
edge of film a between the media guide bar and
after heater, and then insert it into the printer.
While checking at the front and rear of the
printer, align film a with film b tightly.
At the rear of the printer, attach a counterweight
to film a.
a
b
a b