SC-F7100 Series/SC-F7000 Series
G
Pull out the adjustment paper, move it to a
position 5 cm from the right edge of the roll core,
and then insert it into the printer.
Pass the lead edge of the adjustment paper
between the after heater and media guide bar,
and then insert it into the printer.
User's Guide
Appendix
H
136
Keep the adjustment paper taut and check the
positions of the white line on the platen and the
line drawn in Step 6.
If the drawn line and white line are misaligned as
shown in the illustration below, proceed to Step
9. If they are aligned, proceed to Step 10.