Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Taking-up with printed side outU
Printed Side Facing Out" on page 47
Take-up with the Printed Side Facing
In
A
Pass the media through the front side of the
media guide bar, and then attach the media to the
take up roll core with tape.
In the order shown in the illustration, tape the
media to the take up roll core. When attaching in
the center, attach using tape while pulling the
center of the media straight. When attaching on
the left and right, attach using tape while pulling
the media sideways.
c
Important:
If the media is lifted up between the attached
pieces of tape, the media will not be taken up
correctly. If the media is lifted up, we
recommend either adding tape and
attaching it uniformly or fixing creases at
the leading edge of the media.
B
Press the d button in the control panel to feed
enough media for a single wrap around the roll
core.
User's Guide
Basic Operations
C
"Take-up with the
D
45
Flip the Manual switch to
media once around the roll core.
Confirm that the media is not loose.
Confirm differences in tension on the right and
left by lightly tapping on both edges of the media.
to wrap the
Advertisement
Table of Contents
