Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Basic Operations
Loading and Exchanging
Media
The loading method depends on your printer. Choose
the method suited to your printer.
!
Caution:
❏ Be careful not to trap your hands or fingers
when opening or closing the front cover.
Failure to observe this precaution could result
in injury.
❏ Secure the media in place by the following
procedure.
Injury may occur if the media falls.
❏ Do not rub your hands along the edges of the
media. The edges of the media are sharp and
can cause injury.
User's Guide
Basic Operations
Note:
For information on the media that can be used in the
printer, see:
U
When using the SC-F7100 Series
See the following section.
When using the SC-F7000 Series
U
27
c
Important:
❏ Load media immediately before printing. The
pressure rollers may crease media left in the
printer. The media may also become wavy or
curled, causing jams or resulting in the media
coming into contact with the print head.
❏ If the following points are not observed when
handling media, small amounts of dust and
lint may stick to the media surface and cause in
ink drops in the print results.
❏
Do not place exposed media directly on the floor.
Media should be rewound and inserted in its
original packaging for storage.
❏
Do not carry media with the media surface
pressed against clothing.
Handle media in its indivdual packaging until just
before loading the media in the printer.
❏ If media is loaded and the right and left edges
of the roll are uneven, media feeding problems
may cause the media to move around during
printing.
Either rewind to align the edges or use a roll
without any issues.
"Supported Media" on page 112
"Loading Media (SC-F7000 Series)" on page 33
Advertisement
Table of Contents
