Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Note:
Be sure the option selected for Roll Type in the
Customize Settings menu matches how the
media is rolled. Roll Type defaults to Printable
Side Out. Be sure to select Printable Side In after
loading media rolled printable side in.
For more information see U
page 60
E
Raise the lift lever on the left side of the printer to
lift the media into position, then firmly insert the
roll holder.
If the roll of media has an outer diameter which is
less than 140 mm, lift it up by your hands, and set
it to the roll holder. The roll core will not reach
the holder when raised using the lift lever.
F
Tighten the roll holder fixing screw until the
screw no longer turns to fix the roll holder in
place.
User's Guide
Basic Operations
G
"Roll Type" on
H
29
Raise the lift lever on the right side of the printer
to lift the media into position, then firmly insert
the roll holder.
If the roll of media has an outer diameter which is
less than 140 mm, lift it up by your hands, and set
it to the roll holder as described in Step 5.
To ensure the roll holder is inserted into the roll
core sufficiently, push the center section on the
side of the roll holder towards the roll end twice.
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly
during printing because of slippage between
the roll holder and roll core.
This may cause banding in the print results.
Advertisement
Table of Contents
