Epson SC-F7100 series User Manual page 106

SC-F7100 Series/SC-F7000 Series
The print is not positioned properly
on the media.
Is the media loaded correctly and are the
o
margins correct?
If the media is not loaded correctly, the results may be
off center or part of the data may not be printed. Make
sure the loading method suits your setup.
"Loading Media (SC-F7100 Series)" on page 28
U
"Loading Media (SC-F7000 Series)" on page 33
U
You should also check whether the correct options are
selected for Side Margin and Print Start Position in
the setup menu.
"Printer Setup Menu" on page 96
U
Is the media skewed?
o
If Off is selected for Media Skew Check in the setup
menu, printing will continue when the media is
skewed and data will appear outside the print area.
Set Media Skew Check to On in the Menu.
"Printer Setup Menu" on page 96
U
Is the media wide enough for the print data?
o
Although printing normally stops if the print image is
wider than the media, data will be printed beyond the
edges of the media if Off is selected for Media Size
Check in the setup menu. Choose On for Media Size
Check in the setup menu.
"Printer Setup Menu" on page 96
U
Vertical ruled lines are misaligned.
Is the print head misaligned? (in bidirectional
o
printing)
With bidirectional printing, the print head prints while
moving left and right. If the print head is misaligned,
ruled lines may be misaligned accordingly. If vertical
ruled lines are misaligned with bidirectional printing,
perform Head Alignment.
"Correcting Print Misalignment (Head
U
Alignment)" on page 62
The printed surface is scuffed or
soiled.
Is the media too thick or too thin?
o
Check media specifications to confirm that it is
compatible with the printer. If you are using a
software RIP, contact the manufacturer for
information on the settings and media that can be
used.
User's Guide
Problem Solver
o
o
o
o
Ink drops
106
Is the media wavy?
Certain types of media may develop waves under
some conditions (humidity and temperature) while
installed in the printer. If a wave has developed, press
the d button in the control panel to feed the media
and avoid the affected area. We recommend that you
lower the temperature and humidity to prevent
waves developing.
Is the media creased or folded?
Media that is creased or folded may rise from the
platen and contact the print head, resulting in
smudges or uneven colors.
Are the wiper, caps, or print head stained?
Ink clots or lint around the wiper, caps, or print head
may result in stains caused by a build-up of ink. Clean
the affected area.
"Maintenance Around the Print Head" on
U
page 71
Is the print head striking the printed surface?
Smear caused by the print head striking the media can
be prevented by adjusting the Platen Gap to suit the
media.
"Platen Gap" on page 58
U