Epson SC-F7100 series User Manual page 51

SC-F7100 Series/SC-F7000 Series
B
Loosen the roll core holder locking screws and
adjust the roll core holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
C
Align the right roll core holder with the right
edge of the media and tighten the locking screw.
D
Insert the roll core onto the right holder.
User's Guide
Basic Operations
E
F
See the following for further instructions.
For information on taking-up with printed side out, see
the following section.
Take-up with Printed Side Facing In U
the Printed Side Facing In" on page 54
51
Insert the left holder into the roll core.
Slide the holder in until part A in the illustration
below is fully inserted.
c
Important:
Stop when part A is no longer visible. The
take-up reel unit may not function as
expected if the holder is inserted too far.
Tighten the roll core holder locking screw to fix
the roll core holder in place.
"Take-up with